Operation steps of self-loading mixer

2022-02-11 17:02:06
The hydraulic system pressure of the full-automatic small loading mixer should be in accordance with the provisions in the operation manual, and should not be adjusted at will. The quality and quantity of hydraulic oil should meet the original requirements. Before loading, the residual water and debris in the mixing drum should be drained. In the process of transportation, keep rotating to prevent concrete segregation. Before the full-automatic small loading mixer arrives at the construction site and unloads, the mixing drum should be rotated at full speed at 14-18 rpm for 1-2 minutes, and then reverse the unloading. Before reversing, the mixing drum should be stopped stably.

When the temperature in the tank of the full-automatic small loading mixer is higher than 25 ℃, the duration from loading, transportation to unloading shall not exceed 60 minutes, and the above time shall not exceed 90 minutes when the ambient temperature is lower than 25 ℃. During winter construction, it is necessary to check whether there is icing before starting the machine; when off duty, carefully remove the residual water in the mixing drum and water supply system, turn off the water pump switch, and put the control handle at the "stop" position.
After the mixer truck is unloaded at the construction site, the inlet hopper, discharge hopper, discharge chute and other places shall be washed with the hose attached to the mixer to remove the sludge and concrete adhered to the vehicle body. On the way back to the mixing station, 150-200l water should be injected into the mixing drum to clean the concrete residue bonded by the cylinder wall and blades.